wing rules

[Denez]

Need some info. I cannot find anything on the center wing leading edge having to be 5 inchec off the ground is this a WCIS rule? also will each track have templates for the cars to make sure that we are im compliance with the standing rules . I checked on dodc rules could not find anything on the 5 inch rule.

[MiniT21]

Sprint Cars
Must have scale appearing cage, hood, side panels, nerf bars and bumpers. Minimum of a 4 post cage required that resembles a drivers cockpit. A driver arm guard area is permitted on right side panel bust must be of reasonable size. All electronics, radio gear, fuel tanks must be positioned inside the cage side frames. Three dimensional scale appearing exhaust headers must appear on both sides of car in “engine area” and be made of round stock or molded polycarbonate (left side of nitro sprint is optional). Rear cage side panels may be used but may not extend beyond rear cage frame. No lexan or any other material may be mounted to nerf bars, bumpers, cage, wing or any other part of the car that will trap, alter, or direct air flow for the purpose of gaining an aerodynamic advantage. Must have appropriate openings on both sides of cage in driver compartment, forward portion of side panels can be no taller than highest point of hood, no solid side panels.

Maximum Length: 18.000"
Maximum width of hood: 3.600"
Maximum cage width at driver halo, down tubes, and top frame rail: 3.600"
Minimum vertical gap from top of hood to front cage crossbar: .750"
Wing minimum height at leading edge: 5.000" from bottom of chassis

[Denez]

thanks Matt