6x6 Wing Dimension Drawing

[Rob Cutman]

NOTE: This drawing is intended to work in conjunction with the textual sprint car rules on the main rules page. Be sure to consult them as well when refering ot dimensions and wing rules.

http://www.customworksrc.com/article_images/SPRINTCARDIAG2.jpg

[tailslide]

Is there any kick up or turn down allowed on the front and rear edge of the front wing deck?

[rj14]

Is there any kick up or turn down allowed on the front and rear edge of the front wing deck?

yes

[tailslide]

How much?

[93TA]

dale, look at the written rules, it describes it all in length. i believe from memory on a 6x6 molded wing your allowed an additional 1/2" rear spoiler, on a flat panel wing your allowed a 1/4" turndown at the front of the wing, which is to be included in the 6x6 dimension, and u can have an additional 1/2" rear spoiler. but be sure and read the rules for u'r self incase i messed up

[tailslide]

I'm talking about the front wing Larry...

[93TA]

I'm talking about the front wing Larry...


ah... missed that. but, i would assume the written rules also go for the front wing, i.e. a 1/4" turndown at the front of the wing is legal, and none at the back.

rob, can u clarify what is/isn't allowed?

[Rob Cutman]

The max 8 sq inch covers the wing center section from front to back. Basically the chord length from front to back including any turn down or wicker multiplied by the width can not exceed 8 square inches. You can have a 1/2" turn down, a 1" flat and a 1/2" wicker which adds up to 2", as long as it is not more than 4" wide it is fine.

Hope this clarifies it a little better.

Rob

[tailslide]

Thanks Rob

[kerstetter]

AS far as the side panels go what is the rule about turnouts it says front back top and bottom turnouts can be no more than .375" would that be inside the drawing dimensions or outside

[Mason]

read the rest of the sentence in the rules. The doohickeys are included within the max.

[04Xterra]

What is the time frame for the 7x7 buggy tire wing?

[Doug D]

The max 8 sq inch covers the wing center section from front to back. Basically the chord length from front to back including any turn down or wicker multiplied by the width can not exceed 8 square inches. You can have a 1/2" turn down, a 1" flat and a 1/2" wicker which adds up to 2", as long as it is not more than 4" wide it is fine.

Hope this clarifies it a little better.

Rob


Rob - In the rules it says "Wing minimum height at leading edge: 5.000" from bottom of chassis" Is the leading edge from the center foil? Or the leading edge of the right panel bottom corner?

Thanks.

[glgraphix]

Rob - In the rules it says "Wing minimum height at leading edge: 5.000" from bottom of chassis" Is the leading edge from the center foil? Or the leading edge of the right panel bottom corner?

Thanks.
Doug, it measures from the leading edge of the wing. If you are running a CW wing, you would measure to the "fold line" on the front of the foil.
Hope this helps.
Kevin

[Doug D]

Doug, it measures from the leading edge of the wing. If you are running a CW wing, you would measure to the "fold line" on the front of the foil.
Hope this helps.
Kevin

Kevin, I got it now! Thanks.

[04Xterra]

7x7 wing drawing? I had to build a wing and I played very conservative with the dimensions, but I want to make sure I was conservative enough.