1/8 scale quick change rearend

[bill zaren]

hello i was told that you made a quickchange rearend for a 1/8 scale car. well i am built a 4 bar dirt late model chassis and it is using a rockcrawler t-rex 60 rear that is a little narrow , i am using a pin type wheel and a 12mm hex beadlock wheel, 2.2 wheel with a 1.75 width wheel and outside to outside wheel is 11.25" and the final drive is about 2.73, so good for bonneville but not for dirt racing, this car is supposed to make the left rear wheel pull forward ans steer a bit but i dont have bottom end power, i am using a os 21 rg with a ofna lx center diff . 14 tooth clutch bell, 51 diff teeth, with a drive shaft from rcrockcrawling.com so could u email me and let me now what u could do for me.. my email is chevellution72@yahoo.com or here to get me more info.
thanks bill zaren