Aluminum 2.40 Outdrives and CVD Bones!!!!

[RCRACR20]

The JRC aluminum outdrives are in the process of being made. They are lighter than a set of IRS outdrives I had in my bag, and are made of a stronger aluminum. We are taking orders for these. They are $25 a pr. Hoping to have some to take to NC next week also.


The Aluminum CVD bones are $15 a pr, or $7.50 each. We have 100 pr in stock right now, and can get them anytime we want them.

If you have any questions please feel free to PM or email me. Thanks

[RCRACR20]

just an FYI, the outdrives are for the B2/B3/T3 2.40 transmission.

[Team GFRP]

Matt hold 5 sets of cvd's for me I will get them at the open wheel.

[Mike Jeffery]

Matt-
Here is a better quality picture of the 2.40 outdrives.
Thanks,
Mike

[RCRACR20]

Planning on having 40-50 sets of outdrives by the weekend!!!!

[almxdup]

OK Now the one thing missing.... Anyone make a lightweight topshaft like the old Robinson titanium one?

[reghammer]

OK Now the one thing missing.... Anyone make a lightweight topshaft like the old Robinson titanium one?

Someone should, but the old Robinson one was JUNK, the shaft diameter was too small for
the bearing that it used---I can recall at least 50 thrown over peoples shoulders at the track
because they were tired of trashing spurs and center gears.........................but i still have a few if your lookin'

[signman501]

I you have an extra pair of outdrives I will take a set. Name is Glenn Norton.

[KUSTOM-1]

OK Now the one thing missing.... Anyone make a lightweight topshaft like the old Robinson titanium one?
All topshafts are the same including the B4.I just stopped at the local hobbyshop and found 2 titanium topshafts. 15.00 each

[Mark Leber]

All topshafts are the same including the B4.I just stopped at the local hobbyshop and found 2 titanium topshafts. 15.00 each

The B4/T4 topshaft is NOT the same as the B3 or GT. The B4/T4 shaft has no roll pin and is a bit longer.

[RCRACR20]

i believe Ken meant that they use the same press on gear.

[KUSTOM-1]

i believe Ken meant that they use the same press on gear.
Yea ...what he said:o Thanks, Matt

[glgraphix]

Matt, hold me a set of Outdrives and a set of CVD's. Will pick them out a the OW.
THanks, Kevin

[RCRACR20]

Sure thing.


I will have the outdrives in stock at the shop tomorrow morning. I will be bringing whatever does not sell tomorrow after filling orders and racing is over with, to the Open Wheel race, along with some Aluminum CVD bones.

[RCRACR20]

Outdrives are now in stock...anyone who wanted these who are not going to the US Open Wheel Race, please send me a PM. Thanks

[dirtsurfer5]

pm sent!!

[UltraLine Motorsports]

pm sent!!

Matt I could pick a set up for you.

[dirtsurfer5]

thats ok Dan, just stuff me in your suitcase!!

[bill v]

where can i get a pair of the outdrives and a set of cvd's? :tire:

[KUSTOM-1]

where can i get a pair of the outdrives and a set of cvd's? :tire:
Talk to Matt at Redneck R/C-rcracr20