laying down shocks

[Jcr1104]

is there any way to get them laying down shocks to fit on a intimidator gbx kit?

[twisted]

thers a way to do anything if you put your mind to it. make another shock tower and maybe some stand offs to add to the arm to bring the bottem of the shock out further.

[JoeDirt]

drill a hole in the little triangular looking part of the arm, screw in a ball stud and put a ball cup on the end of your shock shaft. will look similar to a terminator

[latemodel13]

I did what greg said . then I found a better way. Drill through the arm where the triangle is at an angle then run a 440 screw through from the bottom that way you can use a captured end on the shock and it won't come off in a crash.