Building a sprint car

[DC Racing]

Hi everyone, just wanted to see if thier was any secrets out there and what are some tips on building the CW sprint car. Also ne one have secrets on the tc3 shocks? Thanks

[BPP]

I would like to know also, I am doing the same.

[latemodel13]

Move the front upper link onto the top screw of the suspension block. You will have to use a longer turnbuckle. Some guys also use a different kingpin that puts the outer link on top of it . I think they use a b-3 pin.

[latemodel13]

I forgot to mention try a set of the tyson springs. Customworks now sells them . They are longer than tc3 but are about 8 lb springs and they are silver. Hope this helps.

[DC Racing]

Ya ive seen those silver spring this weekend on arnie and robs car here at the summer nats. They were dialed. I Got the setup tips from them for my track and asked a few ?'s, but i just need to know about building them. Why use the longer turn buckle and move it?

[latemodel13]

It seems to make it steer a little smoother. I think it takes the camber gain out of the car.

[DC Racing]

When putting in the electronics, were should i put the antenna and how should i mount the switch to the chassis. its a novak so no screw holes. double sided tape will peel off with one push, will a lil drop of c/a work?

[CeO21]

Use a dab of SHO GOO.

[DC Racing]

When installing the gt7 in the sprint and when running the motor mid motor, what is the best way to put the gt7 in and also what is the best way to run the wire from the gt7 to the reciever with a mid motor. the pic in the instructions doesnt help since its rear motor