CVD help for enforcer GSX

[bumps and jumps rc]

Can anyone help me on the length of the GSX cvd length? Is it B4 length or something different. I have a GBX in stock but thats not it and I need it now so hopeully I have the Associated part in stock.

[Mark Leber]

Chris,
The GSX uses a combination of a B4 bone and a GT axle. As far as I know they are only available in kit form from CW but you can rob bones out of a B4 kit if thats all you need. Hope this helps.
Mark Leber

[bumps and jumps rc]

thanks!

[antilley]

http://www.dirtoval.com/forums/showthread.php?t=11954&highlight=CVD+B4


Another thread with a different answer --- are the GT and B3 axles the same? (Looked it up .... and learned something ... didn't know that B3 and GT axles were the same)

I am pretty sure they ship with B4 bones .. B3 axles....I know we run our GSX with B4 bones .... and B4 axles so that we can use the B4 spacer between the drive pin and the bearing.

[Mark Leber]

The GT,T2,B2,and B3 axles are all the same. As mentioned you can run the B4 axles with the spacer but you will be over width if you install B3 wheels and Hpi slicks as it barely makes it with the short axles.
Mark Leber

[antilley]

Do they make a losi axle that would allow you use spacers to push the width out so you can be at max width with a b4 wheel?